Measuring and Marking Out in Plumbing

Overview

Framework:
RQF
Level:
Entry Level 3
Unit No:
M/505/1366
Credits:
3
Guided learning hours:
30 hours

Assessment Guidance

Portfolio of Evidence

For the full unit details, please download the latest version of the qualification specification. This is available for download on the relevant qualifications page.

Unit Learning Outcomes

To view the assessment criteria and any additional content, please expand the relevant learning outcome below.

1 — Know the hand tools and equipment used for measuring and marking out.

Hand tools and equipment

  • tape measure
  • pencil
  • laser level
  • boat level

Assessment Criteria

  • 1.1
    Identify key hand tools and equipment used for measuring and marking out.
2 — Know safety and maintenance requirements for tools.

Safety requirements

  • care and attention with cutting surfaces
  • use of hot working
  • burrs and sharps

Tools storage and maintenance

  • storage of tools with carry bag or toolbox
  • retention of knife blades in holder
  • maintenance of pipe cutter wheels, replace if blunt
  • maintenance of hacksaw blades
  • storage of gas canisters
  • care with blow lamps
  • keeping flux contained

Assessment Criteria

  • 2.1
    State the safety requirements for key tools and equipment.
  • 2.2
    State the basic maintenance requirements for key tools and equipment.
3 — Be able to measure and mark out components.

Know how each is used in plumbing marking out for pipework and fittings

  • marking out pipe runs using a tape measure 
  • use of marker pen or pencil
  • levelling sanitary fittings
  • levelling sinks

Assessment Criteria

  • 3.1
    Follow instructions to measure and mark out different components using
    a) tape measure
    b) spirit level
    c) marking pen or pencil.
4 — Be ble to estimate material requirements for a given installation.

Demonstrate marking out

  • marking out pipe lengths
  • check drainage and pipe diameters
  • measure areas
  • record findings on drawings

Assessment Criteria

  • 4.1
    Measure and record details of length, diameter and area.
  • 4.2
    Record length of pipework, number and type of fittings for given pipework assemblies
5 — Be able to work safely.

Plumbing safety

  • using sharp tools and cutters
  • be aware of burrs on pipework
  • care with cutting
  • wearing PPE where required

Assessment Criteria

  • 5.1
    Follow instructions and requirements in line with current health and safety regulations when using hand tools and equipment.